Tranny ID Swap help

[pyagid]

My xj has the BA 10/5 in it currently. According to www.jeeptech.com


The BA 10/5 is a light duty five speed transmission. It looks similar to the AX-15, but smaller and it is manufactured by Peugeot in France. The input shaft is 1 1/8" 10 spline and the output shaft can be 21 spline or 23 spline.

My question is: Is there a way to determine what output shaft I have with out pulling the T-case off. I have and extra AX-15 sitting at home and figure I might as well swap that in if My t-case will bolt up to it.

Also according to Jeep Tech again


If you own a 21 spline NP231 and you want to swap in a 23 spline transmission, you can either look for a cheap 23 spline NP231 at the junk yard or go to your local Jeep Parts Dealer and order up a new input shaft part #5300-6085. This is the part you need to convert your NP231 to 23 spline input

How difficult would this be to do as well?



Paul

[JeepAngel]

There’s no for sure way to determine the spline count of your output shaft without pulling the t-case. As a general rule of thumb I have been told the 21 spline was on the 4 cylinder and the 23 spline on a 6 cylinder

As for the difficulty going from a NP231 21 spline to a 23 spline input, I have no idea. I searched around online, but can't find anything. Asked Tigger, and he said a bunch of stuff that made no sense to me, so he might have some information for you later

Angel

[Tigger]

EDITED because I am thinking wrong.

[Mudrat]

Paul, 231's are an easy case to work in and on - heck I did it so it must be simple :?
When I put the SYE in mine it really was a piece of cake. [new shaft is the bottom one]

http://members.cox.net/mudrat/Shaft&cluster.JPG

The mongo snap rings were the big problem for me. I broke a pair os snapring pliers - but I got 2 new sets with heavy duty replaceable tips :?

http://members.cox.net/mudrat/231%20T-case/100_0607-B.JPG

It would be easier if you have a press available to remove the needle bearings inside the drive gears - unless your doing the SYE then you throw them away :shock:

http://members.cox.net/mudrat/231%20T-case/100_0613-B.JPG

I was skeptical about that, but the new shaft is much beefyer (is that a word?) and the gears ride on oil pressure instead of bearings.

http://members.cox.net/mudrat/231%20T-case/100_0612-B.JPG

Mudrat :mrgreen: