PDA

View Full Version : I-6 to V8 swap


Bulltear Ad
Bulltear Ad

Too Much Fun
03-01-2004, 09:41 PM
I bought a set of v8 motor mounts and they came with a frame support thing. It is about 1/2 or 5/8 round steel with an offset bend in the middle and tabs on each end. Does anybody know where it goes and which side the offset should be on? Thanks!!

Tigger
03-01-2004, 10:00 PM
The offset should follow the current cross member in your jeep. It sounds like you have the Advance Adapters Chevy 111!!! bolt in saddle mount. The end tabs mount where your stock motor mounts come off.

Too Much Fun
03-01-2004, 10:06 PM
It is not an AA mount. I have seen these on ebay and they are advertised as stock. It came with the stock frame mounts.

Tigger
03-01-2004, 10:09 PM
Sorry I was thinking Jeep YJ...... what type of vehicle is it for?

Too Much Fun
03-01-2004, 10:20 PM
That would probably help a lot 111!!! It is for a cj5

Bulltear Ad