th400 to dana 20 idea is now a reality!

[jeepsr4ever]

Thanks to the members here we have taken steps forward and are now offering this bulletproof adaptor for th400-dana 20's This adaptor replaces all cast adaptors and has alot of extra material where it counts. Its no joke breaking one of these and can cause major damage to your drivetrain. This adaptor is many times stronger than previous castings.

Here is a pic of one near completion
:shock:
http://mpcrescenzo.imgbay.com/NEW%20033.jpg

[CJ Shark]

*Dances on top of chair*

*Chair rolls from underneith*

*Falls to floor*

I think I know someone who could test out the first release :mrgreen:

[pyagid]

*Edit now that we could see the kick ass part



WELL DONE MC :lo1l: now if i only had a use for one

[jeepsr4ever]

We added .100 to the ring landing. The sides are solid except for bolt clearance. The mounting pad is solid and has 1.125 deep tapped holes. Oiling groove was opened up and the mating surface to the th400 has a new geometry that allows more than twice as much torque to be applied before failure, and you can multiply this times the amount that the solid aluminum has over cast. ONE TUFF COOKIE!! We have milled 100lbs of aluminum to get this process right :!:

[Lifted79CJ7]

:shock: :shock: Holy cow MC, that is one beautiful hunk of metal!! :shock: You never sease to amaze me!! :shock: :shock:

[CJ Shark]

Are you going to include the oil seals & bearing when your ready to ship?

And when can I order :t:

[jeepsr4ever]

I can do bearings and seals for $50 installed otherwise these are going to run around 250

[CJ Shark]

If you can find me a couple gaskets to ship with it and throw it all in a box, I'll order one now :t:

Well I'll order one anyways, I just would like the gasket as well :razz:


What do I do to get this baby on the road? :mrgreen:

[jeepsr4ever]

you dont need gaskets with these they have grooves for silicone instead :lo1l:

[Trailbst]

*Edit now that we could see the kick ass part



WELL DONE MC :lo1l: now if i only had a use for one


Paul, I have one that you could use and put in a project. I'll let it go for cheap. :mrgreen:

Erik


P.S. got my DSL hooked up today, and yes I am happy :?

[Renegade360]

So with your adaptor, all I would need is an output shaft to mate with my D18. Where the hell am I gonna find one of those #-o