ILUV2XLR8
05-10-2004, 07:42 PM
Hey guys,
Just wondering if any of you have had this problem or if a red flag pops in your heads.
I just installed a Holley 4150 carb, and a Delco distributor that has a Crane xr-i ignition controller, adjustable vacuum advance and has been recurved (silver/blue springs).
My prob is this, the engine idles fine with the vacuum advance off, when I connect it to the distributor, the motor starts to idle erratically. I'm getting vacuum from the ported vacuum fitting at idle, correct me if I'm wrong, but I thought that this port was'nt suppost to get vacuum at idle. What gives?
Just wondering if any of you have had this problem or if a red flag pops in your heads.
I just installed a Holley 4150 carb, and a Delco distributor that has a Crane xr-i ignition controller, adjustable vacuum advance and has been recurved (silver/blue springs).
My prob is this, the engine idles fine with the vacuum advance off, when I connect it to the distributor, the motor starts to idle erratically. I'm getting vacuum from the ported vacuum fitting at idle, correct me if I'm wrong, but I thought that this port was'nt suppost to get vacuum at idle. What gives?