rollbar
05-16-2004, 02:07 PM
Well I finished the clutch install on the 86' CJ7 last night (T-176), started @ 3:30pm & finished @ 9:30pm cleaned up & ate dinner. One of thoses jobs w/out air & on laying on your back type etc. (shops not set up yet).
I haven't checked the book yet but I have a question: (Stock shifter D-300) I bolted the shifter on the stud but where the shifter end (ball) fits down inside the bracket there was a washer & a rubber gromment, does the washer go on top & the rubber gromment go in the "U" shape bracket, or does the washer go on top of the rubber gromment inside the bracket?
I have the washer on top (outside the bracket & the rubber in the bracket) & the 4x4 works just fine in low/high.
Hope I made since,
RollBar 111!!!
I haven't checked the book yet but I have a question: (Stock shifter D-300) I bolted the shifter on the stud but where the shifter end (ball) fits down inside the bracket there was a washer & a rubber gromment, does the washer go on top & the rubber gromment go in the "U" shape bracket, or does the washer go on top of the rubber gromment inside the bracket?
I have the washer on top (outside the bracket & the rubber in the bracket) & the 4x4 works just fine in low/high.
Hope I made since,
RollBar 111!!!