XtremeOverKill
06-23-2004, 02:46 PM
But which ones...
I'm looking for a few general things, and then a few specifics.
I'm looking 1 to see who are the companies that make Pistons for the 360
I would at least like to know who you guys have used already for purchasing pistions. I'd rather not go custom but if I have to, I want it to be because I have exhausted all of my other options.
Now on to specifics
I would like something in the 9.5:1 to 10.2:1 CR Range with a 62 CC head.
With a Flat section for the Quench zone. I hope to be pushing about 0.035 Quench, and I'd like to have a good flat spot on the piston to Squish all of the molecules where they need to be. - Take some more material out of the Valve releifs - thats fine with me
and at this point I'll consider Cast or Forged slugs. I'd just prefer to stay away from Badger.
Other than that,
I am seeking your advice
I'm looking for a few general things, and then a few specifics.
I'm looking 1 to see who are the companies that make Pistons for the 360
I would at least like to know who you guys have used already for purchasing pistions. I'd rather not go custom but if I have to, I want it to be because I have exhausted all of my other options.
Now on to specifics
I would like something in the 9.5:1 to 10.2:1 CR Range with a 62 CC head.
With a Flat section for the Quench zone. I hope to be pushing about 0.035 Quench, and I'd like to have a good flat spot on the piston to Squish all of the molecules where they need to be. - Take some more material out of the Valve releifs - thats fine with me
and at this point I'll consider Cast or Forged slugs. I'd just prefer to stay away from Badger.
Other than that,
I am seeking your advice