PDA

View Full Version : 96' 4.0, need info.


Bulltear Ad
Bulltear Ad

rollbar
08-01-2004, 06:27 PM
O.K. here's the situation.

1996 Cherokee w/a 4.0 in it ready to be used in another JeeP.

I sold the tranny for the Xj & the guy said he would bring back the crank position sensor so I can start the engine (chry better ideas) if he had it, he's looking tonight.

It's (crank position sensor reads the flywheel) a dumb idea.

Is there any way to start or get it to fire w/out the sensor, I by-passed the neutral safety switch & it turns over but won't fire, I drove it around for a little bit before I sold the tranny so I know it runs.

If he bring the sensor could I just hold it there to get it to fire or do I need the original bell housing of which I don't know if it seperates from the tranny on the 2wd's.

************************************************** **********

*Another one.*

Is there another tranny I could use w/this engine in another JeeP & can I by-pass the computer some how.
There has got to be away because everyone doesn't have the same tranny behind the 4.0 FI, do they?

Thanks everyone,
RollBar

Bulltear Ad