View Full Version : tranny trans info needed
Littlewolf
12-17-2004, 01:38 PM
I have a 1972 commmando with a i6 and three speed . i want to put my 77 cherokee axles under it and the 360 also. my question is what manual tranny and transfer case do i need to be able to keep this a manual instead of going to an auto .
pyagid
12-17-2004, 02:41 PM
Do you know what tranny your currently have? or Transfer case
If the Transfer case is a Dana 20 or dana 18, they You could get a t-18 and put it in there . If it is a dana 300 you could get a t-176, or t-177. Pretty much any manual tranny prior to 86 in CJ's and prior to 1980 in SJ's should work.
You will also need a 360 flywheel for the motor.
I am not to sure what Commandos come stock with, but you definatly have options
and pretty much any descent tranny has an adapter available so you could put a dana 300 t-case on it, and have the passenger side drop axle in the front, center rear
-Paul
Littlewolf
12-17-2004, 02:48 PM
Not sure what is in it , or how to identify it. any ideals on how to tell what they are .
Lifted79CJ7
12-19-2004, 02:58 PM
http://www.jeeptech.com/wiki/index.php/Main
Try this page, it will help you identify whatcha brung to run!!
Jack
Trailbst
12-19-2004, 05:01 PM
Paul, you're book tells you what it is. In a 72 Command with the 6cyl, it was a T-14 3spd. All Jeepster/Commandos came with the Dana 20 transfer case. A T-15 3 spd was offered behind the 304ci V-8. The transfer case will hold up well behind a V-8.
There was also a close-ratio T-18 available.
Axles ratios were 3.73s and 4.27s, with the 3.73s being more common.
HTH
Erik
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.