cobra5laddict
03-01-2005, 01:41 PM
i am at the final stages of assembly on my 360. it is a 80-84 model.
the tappets i got with the rebuild kit are sealed power. the specs are:
height 1.85
width .903
my old lifters are:
height 1.895
width .91
does anyone have a TSM that can look up the factory tolerances for a 360? i have a 1979 TSM but it only covers the 304. it lists the width as: 9.04 - 9.06
the new tappets are sealed power PN ht 2011
any advice guys?
am i going to have a problem with these new lifters being a touch loose in the bore (compared to the orig) and a touch shorter?
thanks guys!
the tappets i got with the rebuild kit are sealed power. the specs are:
height 1.85
width .903
my old lifters are:
height 1.895
width .91
does anyone have a TSM that can look up the factory tolerances for a 360? i have a 1979 TSM but it only covers the 304. it lists the width as: 9.04 - 9.06
the new tappets are sealed power PN ht 2011
any advice guys?
am i going to have a problem with these new lifters being a touch loose in the bore (compared to the orig) and a touch shorter?
thanks guys!