360 pushrods

[Mudrat]

Doesn't give the O/A length, but says they fit and are hardned for guideplates??? The list I have only shows the 70's model lengths at 7.800 70-71 and 7.820 72, Paul - this was an 80-84 block right? Guess I could unwrap them and measure :-|
eBay AMC Pushrods (http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=7964795103&category=33621) - anybody ever hear of these guys?

Mudrat

[pyagid]

Paul - this was an 80-84 block right?

Mudrat

Yes I believe it was, if you look at the casting number in the head, and reference it here http://www.bulltear.com/forum/viewtopic.php?t=541


You will know for sure

-Paul

[fuzz401]

1980 fsm
304/360 push rod length 7.790-7.810
304-360push rod diameter .312-.315

[Mudrat]

Thanks Paul the heads are 3344 and the chart shows 79-84? which tell me the year, forgot about the chart - so much info so little brain 111!!!

And Fuzz - you still Da MAN!!

[jeepmonster]

Pushrod length really should be checked installed to inspect for proper geometry at the valve tip and rocker arm contact. Definately spend a little extra for strong chromoly pushrods. It isnt that hard to bend a stock pushrod on a pumped up motor that you like to drive hard. Ask me how I know :oops:

[tufcj]

AMC pushrods are the same as SBC. When I went to roller rockers on my 390 with 291C heads, I had to use pushrods +.100" to get the geometry right.

Bob
tufcj