Air Gap intake

[Gremlin4ever]

I have a new Edlebrock Air Gap and Street Demon carb going into my current rebuilding of a 401. My question is: Will the stock throttle linkage work on it?

Just trying to get some bugs worked out before I get that far and was wondering if anyone has already installed this intake as of yet.

[Lifted79CJ7]

I know with my edelbrock performer, I had to get a cable bracket to hold my throttle cable for my CJ7. Not sure if their other intakes are the same. Just an FYI - if anyone thinks about buying an edelbrock carb and an edelbrock 14" air filter - you will need a spacer to make them fit together. Go figure!

[fuzz401]

you might need the bracket with the 2 sets of holes
on my air gap I went with the lokar set up for the carb and kick down then i have a elde carb too
http://img.photobucket.com/albums/v31/fuzzcj7/IMG_0533.jpg

[tarior]

I see in the pic of this motor a line coming off the back of the thermostat housing and another one alongside of the carb, what ae these and where do the go?

[fuzz401]

I ran the intake cooling lines
http://img.photobucket.com/albums/v31/fuzzcj7/IMG_0530.jpg
http://img.photobucket.com/albums/v31/fuzzcj7/IMG_0529.jpg