ironman_gq
12-01-2005, 03:06 PM
where is the best place for 304 pistons
View Full Version : 304 pistons
tufcj
12-01-2005, 07:34 PM
In the holes in a 304 block.... :? :mrgreen:
Welcome to the board.
Just a few questions. Stock or higher compression? How are you using it? That will determine if you need forged or cast pistons.
You can look at www.naparts.com or www.fastengineparts.com
Bob
tufcj
Welcome to the board.
Just a few questions. Stock or higher compression? How are you using it? That will determine if you need forged or cast pistons.
You can look at www.naparts.com or www.fastengineparts.com
Bob
tufcj
tarior
12-02-2005, 02:55 PM
In the holes in a 304 block.... :? :mrgreen:
Welcome to the board.
Bob
tufcj
Damn.... you beat me to it! =D> :mrgreen: :mrgreen:
Welcome to the board.
Bob
tufcj
Damn.... you beat me to it! =D> :mrgreen: :mrgreen:
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.