Looking for GW, XJ, ZJ or pickup

[Shaymer]

I'm looking for a late model GW, or an XJ, ZJ, or Comanchee. I'm in Connecticut, but will go anywhere in the northeast. I will need to use it as a daily driver at times, then as a dump runner and snow vehicle.

I've got an 88 GW in my driveway to use as a parts vehicle and already have a 360 in my CJ, so that makes the most sense. Would also consider a cherokee, early model grand cherokee, comanchee, or 4wd pickup or suv. want to spend a grand or two.

Shaymer

[pyagid]

My dad will have his 1995 Dakota up forsale soon. v6 5 speed long bed, 150k miles about. Only thing it needs is the T-case chain needs to be replaced. 2wd works fine, He is still driving it every day. has a limited slip in the rear too. I am not sure of price yet But will post it as soon as i find out

-Paul

[Mudrat]

I'm looking for a late model GW, or an XJ, ZJ, or Comanchee. I'm in Connecticut, but will go anywhere in the northeast. I will need to use it as a daily driver at times, then as a dump runner and snow vehicle.

I've got an 88 GW in my driveway to use as a parts vehicle and already have a 360 in my CJ, so that makes the most sense. Would also consider a cherokee, early model grand cherokee, comanchee, or 4wd pickup or suv. want to spend a grand or two.

Shaymer
Shaymer - I have an 88 GW body that's almost cherry (2 dents, one left front behind the bumper and one on the lift gate from a tree branch), all galss is good and no rust on the frame-AT ALL!. But there is no driveline. If you have a good drive train in yours, I'll drag it up there and give it to you for gas $$ and I get the axles?

Pat, Norfolk

[pyagid]

http://www.yagid.com/coppermine/albums/userpics/10001/PB200015.JPG
http://www.yagid.com/coppermine/albums/userpics/10001/PB200014.JPG http://www.yagid.com/coppermine/albums/userpics/10001/PB200013.JPG http://www.yagid.com/coppermine/albums/userpics/10001/PB200012.JPG

[Smitty]

Is that a long bed on the Dakota? If so, can you measure the inside openings of the bed? Front to back, front side to side and rear side to side. They are supposed to be within half an inch of the J10 long bed dimesnions. I want to order a tonneau cover and want to make sure it is within "fudge" range to make it work. I need the inside rail to rail dimensions, not including the metal lip of the bed.

Thanks

[pyagid]

Is that a long bed on the Dakota? If so, can you measure the inside openings of the bed? Front to back, front side to side and rear side to side. They are supposed to be within half an inch of the J10 long bed dimesnions. I want to order a tonneau cover and want to make sure it is within "fudge" range to make it work. I need the inside rail to rail dimensions, not including the metal lip of the bed.

Thanks

Will do. I will either have my dad do it, or I will do it this weekend when i am down there

-Paul