View Full Version : Quadra Trac Issues
dbesade
01-29-2006, 02:31 PM
Hey everyone,
Last night I was driving with my hubs locked (my QT has a Part time Conversion), and I went to switch into 4WD and well.. nothing. My Switch has been acting up but I can still move it into the right position for 4WD.
But nothing happens in either direction, no 4WD. Anyone have some suggestions on where I should start looking?
-Dave
rollbar
01-30-2006, 04:47 PM
No familure w/the part time kit but did U mean the vac. swith (in cab) is acting up, or the module on the tranny?
Did U check the vac. hoses to the module on the t-case?
Did U check the hubs to make sure they R locked?
Just a thought,
RollBar
dbesade
01-31-2006, 12:00 AM
No familure w/the part time kit but did U mean the vac. swith (in cab) is acting up, or the module on the tranny?
Did U check the vac. hoses to the module on the t-case?
Did U check the hubs to make sure they R locked?
Just a thought,
RollBar
Hubs are locked, triple checked, the part time conversion converts the normally full time QT to part time 4WD. The vacuum hoses to the tranny shouldn't affect the QT engaging into 4WD.
I am not discounting the Module on the Case yet though.
-Dave
rollbar
01-31-2006, 01:24 PM
I know about the part time kit in referance to the hubs etc. I just didn't know if it elminated the vac lines or not. Keep us posted.
thanks,
Rollbar
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.