View Full Version : Bulltear V8 engine mount conversion
High5
01-22-2007, 10:02 AM
I just noticed these in the E store. Will they work for swapping a 8 for a 6 in a 1975 CJ 5????
Less expensive than the MORE mounts.
High5
jeepsr4ever
01-22-2007, 10:29 AM
No they are only for the cars
milnersXcoupe
03-18-2007, 09:02 PM
No they are only for the cars
Will they work in an EAGLE is the question - sell a few if they do :t:
I'm dropping out the front diff - Eagle will be 2wd - street rod -
will your engine mounts THEN work in an EAGLE ? :idea:
hypereagle
05-07-2007, 09:41 PM
[quote=jeepsr4ever]No they are only for the cars
Will they work in an EAGLE is the question - sell a few if they do :t:
I'm dropping out the front diff - Eagle will be 2wd - street rod -
will your engine mounts THEN work in an EAGLE ? :idea:[ Would you possily been discouraged with put a V8 in your Eagle and keep it a 4 wheel drive I can help you out with motor mounts./quote]
jeepsr4ever
05-08-2007, 07:10 AM
If the Eagle has the 2 5/16's mounting bolts in the crossmember plate then they might. Anyone have some pics of a eagle crossmember? To my knowledge the 258 had the same mount in all applications but the 232 had two different mounts (Not that we need to worry about a 232)
milnersXcoupe
05-08-2007, 04:55 PM
Check this site:
http://tinyurl.com/ruqzf
-or-
http://www.users.nac.net/gr/eagleweb/v8eagle/
Eagle has same 258 engine mounts - they're just offset
2" to the passenger side via the cross member.
My understanding of Cams' conversion is that he made up
adapters that bolted to the block and to the 6 engine mounts.
:-|
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.