AMX69PHATTY
03-15-2007, 08:46 PM
The Egge 343 pistons are only 1.570 Comp Ht, not 1.600
Found out talking on the phone with'em today.
They said if ( 10 ) sets are ordered they can make to spec.
Suggestion - 343/360 pistons 1.600 Comp Ht & 15cc dish volume
nominal 3.00 diameter dish by .110 deep with 4 eyebrows
Wouldn't there be a market for 360 cast pistons that would
yield between 9.7 and 10.2 CR using 58cc heads and
depending on deck clearance / deck mill ?
If deck and heads were both milled .012, then 0.000 deck and 10.2 CR
If combustion chambers were re-worked and opened up then lower than 10.2 CR
Just an idea.
Found out talking on the phone with'em today.
They said if ( 10 ) sets are ordered they can make to spec.
Suggestion - 343/360 pistons 1.600 Comp Ht & 15cc dish volume
nominal 3.00 diameter dish by .110 deep with 4 eyebrows
Wouldn't there be a market for 360 cast pistons that would
yield between 9.7 and 10.2 CR using 58cc heads and
depending on deck clearance / deck mill ?
If deck and heads were both milled .012, then 0.000 deck and 10.2 CR
If combustion chambers were re-worked and opened up then lower than 10.2 CR
Just an idea.