View Full Version : Need help again
I need a pic of how the front of the engine goes togeather from the timing set outward with a description of each part.
Thanks
Brek
fuzz401
06-04-2007, 09:33 AM
http://img.photobucket.com/albums/v153/fuzzgremlin/cam_gear.jpg
Thanks fuzz!
On the crank all there is, is the oil slinger correct? If so is the oil slinger just flat or beveled?, if beveled which was does it go?
I know all of this probably sounds stupid, but I was not involved in the teardown of my engine, and my bro doesen't remember what came from where (dumb azz).
fuzz401
06-04-2007, 10:09 AM
http://img.photobucket.com/albums/v31/fuzzcj7/IMG_0504.jpg
Mudrat
06-30-2007, 10:51 AM
of a red block
Fuzz, the last time I was in your garage the block was black?? You doing a swap out or building a new one??
fuzz401
06-30-2007, 05:33 PM
Fuzz, the last time I was in your garage the block was black?? You doing a swap out or building a new one??
thats the black one I used elec motor paint to help oil flow and keep the oil clean from the cast iron but I am thinking about the next motor to build #-o
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.