truray4
01-31-2008, 03:27 PM
I am looking to build an AMC 390 bored 20 over. I am running a set of hyper pistons at 10.5:1 compression.
I am looking to run the edelbrock aluminum heads with crane energizer roller rockers. Will these fit on the heads without any modifications? I am also going to be running a crane crankshaft (part number 864561) it has 232 int./242 exh at .050 lift. Will the edelbrock chrome valve cover (3" tall, clear everything ok?)
I am going with a full msd ignition using the new MSD box, distributor and coil. For fuel I am running the edelbrock electric fuel pump set at 6.5 psi and 120 GPH free flow rate with a Holley 4150 750cfm carb. The headers will be a set of Dougs 1 3/4 with ceramic coating.
For the oil system I am going to run the full BullTear oil system kit with a Milodon oil pan and pick up. I have also done the gallery oil by pass on the block.
WHAT I HAVE MISSED?? Or does anyone have any recommendations??
The car will be a mostly street driven 66 AMC Rambler.
Thanks
I am looking to run the edelbrock aluminum heads with crane energizer roller rockers. Will these fit on the heads without any modifications? I am also going to be running a crane crankshaft (part number 864561) it has 232 int./242 exh at .050 lift. Will the edelbrock chrome valve cover (3" tall, clear everything ok?)
I am going with a full msd ignition using the new MSD box, distributor and coil. For fuel I am running the edelbrock electric fuel pump set at 6.5 psi and 120 GPH free flow rate with a Holley 4150 750cfm carb. The headers will be a set of Dougs 1 3/4 with ceramic coating.
For the oil system I am going to run the full BullTear oil system kit with a Milodon oil pan and pick up. I have also done the gallery oil by pass on the block.
WHAT I HAVE MISSED?? Or does anyone have any recommendations??
The car will be a mostly street driven 66 AMC Rambler.
Thanks