fifesjeep
05-25-2008, 08:59 PM
1980 CJ7
AMC 401 (reman) with Offroad 670cfm Truck Avenger, Edelbrock Performer intake, 2 into 1 exhaust, I have Competition inframe hooker headers (not installed).
Ford T18 Granny
Dana 20 Twin Stick with 3.15 gears and HD output shafts.
SOA
Dana 60 front, 4.56 gears, Locked, Long side narrowed.. I have two extra outer shafts. Axle has been pushed forward about an 1"
FF 14 Bolt Rear 4.56 gears, Locked Drum brakes (I have partial disk brake kit) Axle has been pushed back a couple inches
Humvee 8 lug Run-Flat Beadlocks
38" Super Swampers with two new Spares
Tub Has been Cut
Side/Rear 1/4" body armour
Side/rock rails
6 point cage tied to the frame
HD Steering Mounts/brackets
Power Brakes
DUI HEI with Live wires
Fiberglass Windshield frame
Hardtop with Hard Doors
Custom Tube Cross Member
Custom Flat Fenders
Custom Stinger
Custom 14 bolt 1/4" thick differential cover
Custom Shock mounts
Custom rear bumper
Water proof seats (I can't remember the brand, I'll have to look through the papers)
Revolver shackles (Hate'em)
HD Traction Bar
Dual Flex-a-lite Fan (Soon to be a Ford Taurus Fan)
I have a York 210 Compressor... the mount is already in-place, just needs the basic hardware and clutch/pulley.
There are a lot of various "extra" parts that will go along... Basic stuff, starters, alternators, extra warn hubs etc...
I have duty tomorrow... PM me for pictures etc... By the middle of the week I'll post pics... any specific pics please let me know.
AMC 401 (reman) with Offroad 670cfm Truck Avenger, Edelbrock Performer intake, 2 into 1 exhaust, I have Competition inframe hooker headers (not installed).
Ford T18 Granny
Dana 20 Twin Stick with 3.15 gears and HD output shafts.
SOA
Dana 60 front, 4.56 gears, Locked, Long side narrowed.. I have two extra outer shafts. Axle has been pushed forward about an 1"
FF 14 Bolt Rear 4.56 gears, Locked Drum brakes (I have partial disk brake kit) Axle has been pushed back a couple inches
Humvee 8 lug Run-Flat Beadlocks
38" Super Swampers with two new Spares
Tub Has been Cut
Side/Rear 1/4" body armour
Side/rock rails
6 point cage tied to the frame
HD Steering Mounts/brackets
Power Brakes
DUI HEI with Live wires
Fiberglass Windshield frame
Hardtop with Hard Doors
Custom Tube Cross Member
Custom Flat Fenders
Custom Stinger
Custom 14 bolt 1/4" thick differential cover
Custom Shock mounts
Custom rear bumper
Water proof seats (I can't remember the brand, I'll have to look through the papers)
Revolver shackles (Hate'em)
HD Traction Bar
Dual Flex-a-lite Fan (Soon to be a Ford Taurus Fan)
I have a York 210 Compressor... the mount is already in-place, just needs the basic hardware and clutch/pulley.
There are a lot of various "extra" parts that will go along... Basic stuff, starters, alternators, extra warn hubs etc...
I have duty tomorrow... PM me for pictures etc... By the middle of the week I'll post pics... any specific pics please let me know.