dustym
08-09-2008, 06:52 AM
Just typed in question and messed up, so here is a shorter version.
60 miles on rebuild. lifter/rockers were ticking, oil level ok, but stock gauge shows very high pressure (70-80 psi) and wouldnt change from idle to cruise. 1 lifter was not torqued down anymore. While priming 3 lifters are not getting oil up through pushrods(new pushrods,cam, lifters), #3 intake, #4 and 5 Exhaust. Oil seems to be shooting out of pass side but flows steady from drivers side.
Any Ideas?
60 miles on rebuild. lifter/rockers were ticking, oil level ok, but stock gauge shows very high pressure (70-80 psi) and wouldnt change from idle to cruise. 1 lifter was not torqued down anymore. While priming 3 lifters are not getting oil up through pushrods(new pushrods,cam, lifters), #3 intake, #4 and 5 Exhaust. Oil seems to be shooting out of pass side but flows steady from drivers side.
Any Ideas?