brokenjeeper
11-13-2008, 11:17 AM
Gents.,
I was wondering if someone might be able to assist me in getting some ballpark HP and Torgue figures from a desktop dyno. The engine is a 401 bored .030 over with stock style cast pistons, edelbrock dual plane performer intake, edelbrock heads, stock exhaust manifolds, and running the following cam:
HC267/320 Adv. dur. 267, dur. @.050 214, .320 lift on 112 deg. lobe center with 1.6 to 1 rockers. The fuel delivery might be from a 670 cfm tbi unit. I am trying to figure out how feasible it might be to try and map the correct fuel curve for a tbi using this set-up or move on to propane. I've also tried using some of the .torrent desktop dynos, but the default values for small blocks cannot be changed. Your help is appreciated.
I was wondering if someone might be able to assist me in getting some ballpark HP and Torgue figures from a desktop dyno. The engine is a 401 bored .030 over with stock style cast pistons, edelbrock dual plane performer intake, edelbrock heads, stock exhaust manifolds, and running the following cam:
HC267/320 Adv. dur. 267, dur. @.050 214, .320 lift on 112 deg. lobe center with 1.6 to 1 rockers. The fuel delivery might be from a 670 cfm tbi unit. I am trying to figure out how feasible it might be to try and map the correct fuel curve for a tbi using this set-up or move on to propane. I've also tried using some of the .torrent desktop dynos, but the default values for small blocks cannot be changed. Your help is appreciated.
