View Full Version : Hydraulic Lifters
DolceCJ
05-10-2009, 12:43 PM
For my AMC 360. After soaking in oil for 5-6 hours is it recommended I push down on each lifter with the push rod to bleed out any excess air before installation?
Mudrat
05-10-2009, 02:57 PM
Two schools of thought on that one:
First - Yes, ensures all the air os bleed out
Second - No. pumps the lifter up too much on intial turnover of the engine and could "possibly" wipe a lobe.
I just soak'm and install'm
JERSEYJOE
05-10-2009, 08:39 PM
I soak them over night then wipe the off before I put assembly lube on the cam end.
When you prime the engine with the pre-oiler you are going to pressure up the lifters any way. When doing so I like to turn the engine 90 degrees ( with a breaker bar not the key) and run the priner tool for a couple of minutes every 90 degrees. This way all the lifters get a change to oil up.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.