jpcjguy
08-02-2009, 08:05 PM
Hey all,
So before I put on the AFI throttle body kiton my 360, I figured I might as well redo the head gaskets as one was leaking a little bit. Good times.. :?
Pulled the heads everything looks ok - as far as I know :mrgreen:
I am curious about these pistons - they are not stock - can anyone identify them? Are they "flat top" Supposedly the block is bored .030.... Had an edelbrock intake and stock cam.
and might I add that it is a ROYAL PITA to do this - took a coolant bath, had to remove the AC compressor (on board air), power steering pump, etc. :(: :mrgreen:
Pics:
http://lh5.ggpht.com/_lpKDc0h39s8/SnZGlSzhEdI/AAAAAAAAADI/b6O2KGypjhU/s800/piston2.jpg
http://lh5.ggpht.com/_lpKDc0h39s8/SnZGbRu1XrI/AAAAAAAAAC8/KCsqnN0L1pw/s800/piston1.jpg
So before I put on the AFI throttle body kiton my 360, I figured I might as well redo the head gaskets as one was leaking a little bit. Good times.. :?
Pulled the heads everything looks ok - as far as I know :mrgreen:
I am curious about these pistons - they are not stock - can anyone identify them? Are they "flat top" Supposedly the block is bored .030.... Had an edelbrock intake and stock cam.
and might I add that it is a ROYAL PITA to do this - took a coolant bath, had to remove the AC compressor (on board air), power steering pump, etc. :(: :mrgreen:
Pics:
http://lh5.ggpht.com/_lpKDc0h39s8/SnZGlSzhEdI/AAAAAAAAADI/b6O2KGypjhU/s800/piston2.jpg
http://lh5.ggpht.com/_lpKDc0h39s8/SnZGbRu1XrI/AAAAAAAAAC8/KCsqnN0L1pw/s800/piston1.jpg