Used Gum
08-19-2009, 08:31 PM
360 Build Sheet:
.030 over w/new cast pistons
Edelbrock cam, heads, intake, T/C
Howell TBI w/DUI
Can you port the stock manifolds? If so, is it worth the "grind time?"
*asking because looking inside there is a "step" that looks as though it would hinder flow. But then again, was it there for a reason and needs to be left alone ?!
.030 over w/new cast pistons
Edelbrock cam, heads, intake, T/C
Howell TBI w/DUI
Can you port the stock manifolds? If so, is it worth the "grind time?"
*asking because looking inside there is a "step" that looks as though it would hinder flow. But then again, was it there for a reason and needs to be left alone ?!