View Full Version : No serial port???
tuf045
04-10-2010, 03:23 AM
hi there i'm new to this and have purchased a 4x8 gantry kit and had it shipped to Australia. I have run in to some small problems one being my computer has a parallel port but no serial port so i'm wondering if i can use a usb to db9 adaptor?
thanks Wes.
jeepsr4ever
04-10-2010, 07:20 AM
You should only nee one parallel port (DB25) for operation. Their are 2 DB9 ports on the boxes. One hooks to a remote pendant (You can use a xbox 360 controller for that (USB PC)) and the other hooks to your DTHC card.
tuf045
04-10-2010, 07:24 AM
o.k will have another read of the candcnc manuals! cheers.
jeepsr4ever
04-10-2010, 07:25 AM
I you get a chance post up a pic of your finished table :wink:
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.