amundaza
05-03-2010, 10:31 AM
Hey guys,
This is a nearly new Edelbrock Performer intake for 70 + up V8's. It was on a 70 AMX for about 200 miles and then pulled off. It was so clean, there wasn't even oil residue on the bottom. The top side received a quick bead-blast. Next, I installed an oil filler tube and then powdercoated it and the thermostat housing in Eastwood's single stage chrome. I also added some carburetor studs for holding down the t-stat housing.
Asking $220. Thanks!
http://i246.photobucket.com/albums/gg116/amundaza/AMC%20Parts/100_2146.jpg
http://i246.photobucket.com/albums/gg116/amundaza/AMC%20Parts/100_2147.jpg
http://i246.photobucket.com/albums/gg116/amundaza/AMC%20Parts/100_2148.jpg
This is a nearly new Edelbrock Performer intake for 70 + up V8's. It was on a 70 AMX for about 200 miles and then pulled off. It was so clean, there wasn't even oil residue on the bottom. The top side received a quick bead-blast. Next, I installed an oil filler tube and then powdercoated it and the thermostat housing in Eastwood's single stage chrome. I also added some carburetor studs for holding down the t-stat housing.
Asking $220. Thanks!
http://i246.photobucket.com/albums/gg116/amundaza/AMC%20Parts/100_2146.jpg
http://i246.photobucket.com/albums/gg116/amundaza/AMC%20Parts/100_2147.jpg
http://i246.photobucket.com/albums/gg116/amundaza/AMC%20Parts/100_2148.jpg