PDA

View Full Version : Powermax 45 Plug? and Air Dryer Filter


Bulltear Ad
Bulltear Ad

FiveORacing
10-18-2010, 05:53 PM
Hi:
Setting up the garage in prep for a BT Table and was hoping someone could tell me what the plug (spade) configuration is on a Powermax 45?

I don't have the unit yet but I'm wiring up the garage.

It will be the 230 single phase version.


Also what would be a decent air/oil dryer setup to look at without spending a small fortune, or at least what's working for you. I have a cheap water separator at the compressor now and it's pretty obvious it doesn't get it all, especially after a few minutes of using air. Everything I've read states it's critical to have clean dry air.

Thanks!!

Joe

FiveORacing
11-06-2010, 07:48 AM
Bought the Air/oil seperator/dryer. Hoping someone could tell me what plug is on a 45 so I can have it set up when it arrives??

Joe

Creepy
11-13-2010, 09:03 AM
The plug size is listed in the powermax manual. There are different ones for different markets. Go to the hypertherm site and look at the manual.

Bulltear Ad