FiveORacing
10-18-2010, 05:53 PM
Hi:
Setting up the garage in prep for a BT Table and was hoping someone could tell me what the plug (spade) configuration is on a Powermax 45?
I don't have the unit yet but I'm wiring up the garage.
It will be the 230 single phase version.
Also what would be a decent air/oil dryer setup to look at without spending a small fortune, or at least what's working for you. I have a cheap water separator at the compressor now and it's pretty obvious it doesn't get it all, especially after a few minutes of using air. Everything I've read states it's critical to have clean dry air.
Thanks!!
Joe
Setting up the garage in prep for a BT Table and was hoping someone could tell me what the plug (spade) configuration is on a Powermax 45?
I don't have the unit yet but I'm wiring up the garage.
It will be the 230 single phase version.
Also what would be a decent air/oil dryer setup to look at without spending a small fortune, or at least what's working for you. I have a cheap water separator at the compressor now and it's pretty obvious it doesn't get it all, especially after a few minutes of using air. Everything I've read states it's critical to have clean dry air.
Thanks!!
Joe