stidham13
01-13-2011, 10:12 PM
I'm taking my 1973 360 block i picked up in a waggy to the machine shop tomorrow.
Its going in my 76 CJ-7 in place of a tired 304
Have a few questions about what oiling mods need to be done.
The build will be pretty mild, Edelbrock intake, about 9 to 1 compression, crane H-260-2 cam, truck avenger carb, stock exhaust manifolds, dual exhaust
I was planning on ordering the increased pressure cam bearings, new timing cover with a midplate.
Is there any need to do any other mods that I need on an engine that will never see 5000 Rpm.
Any other things to watch out for.
I'm open to other suggestions before I get in too deep also.
Thanks for the help I'm new to AMC engines but this seems like the place to be to get help.
Its going in my 76 CJ-7 in place of a tired 304
Have a few questions about what oiling mods need to be done.
The build will be pretty mild, Edelbrock intake, about 9 to 1 compression, crane H-260-2 cam, truck avenger carb, stock exhaust manifolds, dual exhaust
I was planning on ordering the increased pressure cam bearings, new timing cover with a midplate.
Is there any need to do any other mods that I need on an engine that will never see 5000 Rpm.
Any other things to watch out for.
I'm open to other suggestions before I get in too deep also.
Thanks for the help I'm new to AMC engines but this seems like the place to be to get help.