XBOX controller instructions?

[FiveORacing]

Any chance we could get these reposted?

Thanks

[jeepsr4ever]

This file allows your computer to see the Xbox controller

http://download.microsoft.com/download/0/0/f/00f2a67b-e10b-43b1-8cca-3deb12218f75/Xbox360_32Eng.exe

This file allows Mach 3 to see and installs special options

http://www.machsupport.com/plugins/XBox360Controller.m3p

Both files should be located on your BTA CNC plasma setup disk. After loading and restarting go to Mach "config", "plug ins" and toggle the red X on the Xbox 360 controller to a green check mark and slick the ocntroller to bring up the button interface. You may have to restart mach to get the controller to work with your plasma table.

[FiveORacing]

Thank you very much. Table is cutting nice!!!!