PDA

View Full Version : Table is down.


Bulltear Ad
Bulltear Ad

wickedinhere
11-10-2011, 02:57 PM
I noticed some noise from my gantry this morning then it started cutting out of round. I started looking around and everything was tight as could be so I started checking and found the noise coming from the y axis motor OH great. I pulled the spring off of the motor plate to make sure the torch mech was sliding good and it was. I pulled the motor
and the pinion set screw had slightly loosened not much but it would move ever so slightly. I pulled the set screw put some more locktite on it and now i am waiting on it to dry. I have been running the table alot and have to say if this is all the trouble i have with it i am in great shape.

wickedinhere
11-10-2011, 05:37 PM
Well i got some more problems it seems the v rollers on the torch mech have a lot of play and are causing the motor pinion to tilt up thats where the noise was coming from. THe v rollers have a good bit of grease coming out of them. Heres a video of the slack. HELP PLEASE. I did call bulltear but it was late so i hope to hear from them tomorrow.
http://i20.photobucket.com/albums/b235/wickedinhere/th_IMG_0701.jpg (http://s20.photobucket.com/albums/b235/wickedinhere/?action=view&current=IMG_0701.mp4)

wickedinhere
11-10-2011, 07:20 PM
Well i figured out how to tighten the v rollers. But the pinion is still noisy and causing a vibration,when i remove the spring it is quiet as can be. I think i need a new pinion.

wickedinhere
11-10-2011, 07:54 PM
Here is a video of the noise i dont see any damage to the rail or the pinion with the spring removed it doesnt make the noise.
http://i20.photobucket.com/albums/b235/wickedinhere/th_IMG_0699.jpg (http://s20.photobucket.com/albums/b235/wickedinhere/?action=view&current=IMG_0699.mp4)

jeepsr4ever
11-11-2011, 06:33 AM
Yes you got something stuck on your gear. Inspect it carefully a small piece of slag will do that. There are cam bolts for the V wheels, I see you found those.

wickedinhere
11-11-2011, 07:17 AM
Yeah i am gonna pull the motor back off and look at that pinion real close.

Brian1
11-11-2011, 10:33 AM
If you dont find anything on the pinion gear clean and then spray some white lithium grease on the rack gear and then run it side to side. That helped my noise and skipping problem.

jeepsr4ever
12-07-2011, 02:24 AM
Hey are you running? Need any more help?

wickedinhere
12-07-2011, 12:08 PM
Running smoth as ever. THanks for the support i am itching for one of the new 4x8 tables.

Bulltear Ad