Need t150 bellhousing measurements

[65postgs]

Does anyone have a t150 bellhousing handy that can take some measurements for me?

I need to make a pivot ball pedestal as mine is missing.

I need the length of the pedestal from tip to where the bellhousing surface that mounts to the trans, the diameter of the pedestal and the depth of of the groove where the ball sits.

I need this in order to get my cj5 back on the road.

Any help would be greatly appreciated.

[tufcj]

Got a couple in the shed. I can take the measurements or I'd sell you one for $75 plus shipping.

Bob
tufcj

[65postgs]

Got a couple in the shed. I can take the measurements or I'd sell you one for $75 plus shipping.

Bob
tufcj

Measurements would be great as it has already been modified for the ih t19 bolt pattern

[65postgs]

ttt

[tufcj]

Sorry about the delay. Been on call at work and putting in some long hours.

Bob
tufcj

[tufcj]

I need the length of the pedestal from tip to where the bellhousing surface that mounts to the trans

I measure 1.495" at the tallest. It varies about .020" because of the rough casting.



the diameter of the pedestal

It measures .835" at the top. .920" at the bottom. The casting is tapered.


the depth of of the groove where the ball sits.

This one is approximate, I get .275". It's tough with the rough top of the casting and the curved bottom of the hole.

The ball is .625" in diameter.

Hope this helps.

Bob
tufcj