PDA

View Full Version : Lost Power to Stepper Motors


Bulltear Ad
Bulltear Ad

stillworkin
11-18-2012, 12:00 PM
Machine was working great until friday, after i loaded my material onto the table the power from the box to the motors shut off. The red led next to the OFF button still stayed lit, and i am able to turn power to the box on and off but when i press the on button nothing happens. Also, once i flip the switch to turn power onto the box i notice that the bottom fan doesnt come on. I don't know if it is supposed to or not but just an observation. I took the front cover to the box off and found a small blue jumper sitting in the bottom of the box. I assume when i loaded the metal it vibrated off. Does anyone have a diagram i can look at to compare and find where the jumper goes?

Thanks,
Martin Fountain

jeepsr4ever
11-18-2012, 01:19 PM
There are jumpers all over in the control box. Did you try pressing in the circuit braker on the side?

stillworkin
11-18-2012, 11:32 PM
My breaker is on the bottom but yes I tried pushing it but it wasntt triped

jeepsr4ever
11-19-2012, 01:47 AM
Do you get any blinking lights? PM sent

stillworkin
11-19-2012, 02:17 AM
When i first flip the switch on the red led @ the off button comes on and then the Z and X led lights flash red once. After that i have nothing.

Bulltear Ad