View Full Version : AMC 390 Heads
dmcjeep
12-21-2012, 10:54 AM
I looked at an AMC 390 today and the heads havew the dog leg portd. Can someone tell me if that would be correct? I always thought they had the square port heads. The head numbers if it helps are:
3188558-2. Any help would be appreciated. Thanks
jeepsr4ever
12-21-2012, 01:06 PM
Someone ground them in
tufcj
12-22-2012, 01:25 AM
That's the correct casting number for 68/69 390 heads, but if the ports aren't square, someone worked on them. Those were all square from the factory.
Bob
tufcj
dmcjeep
12-22-2012, 09:31 AM
Thanks I thought that was the case I just am not real familiar with those older motors/heads.
A 390 has dog leg heads with 92.25 cc heads.Very rare ,if you want compression thats a good start.
jeepsr4ever
01-12-2013, 06:21 AM
1970 only had the doglegs and what they did was make the chamber a little smaller but the later heads made up for that by flowing better. IMHO 1970 heads arent worth the trouble.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.