CBRMetalworks
05-14-2013, 12:56 PM
I didn't notice this until I cut something today that had to be right (bracket for a truck), most of the time cutting a sign or something it doesn't matter if it comes out +/- 1" in size.
I had something drawn in CAD that was 27", it cut at about 26.25", the whole piece is wrong (all the holes are in the wrong spot).
What could I be doing wrong? It cant be a inch/mm problem because it is only off a relatively small amount, there is no slop in the table either.
I had something drawn in CAD that was 27", it cut at about 26.25", the whole piece is wrong (all the holes are in the wrong spot).
What could I be doing wrong? It cant be a inch/mm problem because it is only off a relatively small amount, there is no slop in the table either.