J(o)(o)SE
08-01-2013, 01:31 PM
Just wondering how fast everyone normally runs their tables? I've been cutting a lot of stuff between 12g and 1/4" with some pretty crisp cuts, but some of the thinner stuff I have cut gets a little rough as the speeds increase. I've been meaning to pick up some 30A consumables for my hypertherm to slow things down when doing thin stuff, but right now anything 150 ipm and up isn't coming out as clean as I'd like.
It would be nice to know how fast others are running their machines while still getting clean cuts. Any tips for reducing the wiggle on direction changes at higher speeds?
It would be nice to know how fast others are running their machines while still getting clean cuts. Any tips for reducing the wiggle on direction changes at higher speeds?