RAM OFFROAD
09-11-2016, 07:26 PM
Hey ya'all,
Been cutting a lot of metal but just getting into aluminum. I've cut 1/8" and 3/16" without issue, but 3/8a' inch and 1/2" are being problamatic. I have a Hypertherm 65 rated to cut 1/2" alum. Start lab wet table. Mach3. I get really bad cuts no matter what settings I've tried. Here is a pic of the crap I'm getting. Any help will be greatly appreciated. 567
Been cutting a lot of metal but just getting into aluminum. I've cut 1/8" and 3/16" without issue, but 3/8a' inch and 1/2" are being problamatic. I have a Hypertherm 65 rated to cut 1/2" alum. Start lab wet table. Mach3. I get really bad cuts no matter what settings I've tried. Here is a pic of the crap I'm getting. Any help will be greatly appreciated. 567