PDA

View Full Version : First gen System and need help


Bulltear Ad
Bulltear Ad

sadisticiron
11-12-2017, 01:33 PM
I have a first gen bulltear cnc gantry kit with a candcnc bladerunner DTHC controller. Recently my original cpu that’s been running the system for the past 7 years finally crashed. I purchased a new/ vintage vista cpu and need the original setup canccnc bladerunner AIO Setup disk as all the new Mach 3 and candcnc downloads are not the same as the originals. Any help would be appreciated greatly

jeepsr4ever
11-13-2017, 09:56 PM
Vista will not work at all. You need 32 bit xp. Use the pre 2014 legacy master installer. Install mach 3 first then the bladerunner dthcii pre 2014

Bulltear Ad