1 Attachment(s)
Independent home/gantry squaring switch kit now available
ATTENTION 2012HD AND STAR-LAB OWNERS (full table and gantry kit users)
http://www.plasmaland.com/product_in...products_id=49
This kit allows users from our late 2011 to 2014 (4 motor systems) and Star-Lab owners the ability to auto square the gantry and auto home Both X and Y axis. The auto-square function will independently move X and A axis after one hits a switch. This superb functionality will give you a home/square ability on your gantry kit or full table. Y axis home included. This kit also fits all Star-Lab tables in ANY axis and configuration. Kit includes, 2 brackets with 2 switches for X and A, Y axis bracket with 1 switch, 3 long wires with spade terminal ends and 2 rail end caps with setscrew and lock adjustability
Attachment 434
Gantry out of square ; X-cuts
Hey Matt,
My gantry is out of square square(Y-drifting on X-cuts)(straight Y-cuts)
I do not have this switch set-up on my 2014 4x8 Star-Lab/Bladerunner kit.
The kit is not available @Plasmaland/link. :sad10:
Can I get some help with this?
Method to square is:
power down Bladerunner
measure Y:ends
move gantry manually until measurements look good
power up
measure
if holding square then:
cross fingers/hit run for cuts
typically holds stepper position until next power-up.
Repeat.
My motor #s are matched in CommandCNC config.