-
I use the Centreforce dual friction set up for the clutch.As for everything else i did have problems with the throwout bearing wearing out to much.What i did was replace the linkage with heims that i built and through together as ends and replaced the front bearing retainer sleeve[throw out bearing also runs on the outside of this piece] and havent looked back.It did take a bunch of screwing around to fine tune but i had that problem before the swap so i cant blame the tranny!Hope this helps Mike :wink:
-
I used the centerforce setup as well,and tried to use the throw out bearing (N-1439)but it wouldn't fit over the retainer sleeve. used one from a '79 model w/ a three speed and thought it was good. but a few hundred miles down the road it starts singing. I mught try a new retainer sleeve. I should have replace it when I got the tranny rebuilt... but you know how it goes. plus most redneck tranny shops around here have no idea of whats going on, so no help there.. :(: how I dread pulling that heavy transmission :(: .. thanks
-
This post reminded me of how I take more time before posting. Man look at my spelling... :?:
-
after a few :razz: :razz: :razz: we all have spelling issues
:mrgreen: 8)
-
If my memory serves me correctly i think i used a ford 614038 throw out bearing friom National BCA Bearing!It is greaseable and has served me well !7 years since its been apart!Mike :!:
-
if im not mistaken that throwout your talkin aboot is also for a jeep with a 232 I-6 w/lever style clutch..........heavy duty cast one w/grease fittins?
-
Its been so long since i did the swap and the screwing around but that sounds about right! :sa: