No worries, i can take the other one back to the parts store and get the 61031
Printable View
No worries, i can take the other one back to the parts store and get the 61031
Trying to install Idler on water pump side of serpentine kit 1st picture shows pulley down and second picture shows it in up position niether seems to work on mine
does the long bolt go in place of bolt that holds the pump bracket? if so where does the arm attach?
What is the serpentine belt length for York compressor systems? I see gates part #K060915 (92.125" long) cited previously in this forum and K061031 (103.67" long) on the product description (http://www.bulltear.com/catalog/prod...roducts_id=247). Which is correct? Thanks -
k061031
I cannot get the york compressor pulley to line up with the other pulleys (76 wagoneer 401 with horizontal york). All of the other pulleys line up but the york compressor is too far towards the motor by ~ 1/2". I rechecked and I did buy your serp kit for the York not the Sanden. Do you have any detailed pictures of the bolt set-up with the york? The only instructions I see on your website is the non-ac kit.
The York aluminum bracket must be spaced out using the spacers that came with the kit. This will eliminate the steel bracket.
Do you have any detailed pictures of this setup? Do the spacers go behind the stock lower aluminum bracket? Can I leave the York horizontally mounted or do I have to mount it vertically like the pic on your website with the Javelin motor? Can I just eliminate the York with the current pulley setup? If so, do you have a part # or length of the required belt? Thanks-
You space out the York using the spacers behind the original bracket. You can mount it vertically or horizontal it can be mounted any way.