Back in action!
Tom had posted a diagram for me to confirm the yellow wire went to pin 1 on the cover plate. Working great again!
Type: Posts; User: J(o)(o)SE
Back in action!
Tom had posted a diagram for me to confirm the yellow wire went to pin 1 on the cover plate. Working great again!
pretty sure the yellow wire goes to the #1 pin, however I'm not about to hook it up without knowing for sure. I've tried looking through the schematics that were loaded onto my pc that I got with the...
Finally picked my board up from parcel place, hooking it up now. Took note of how everything plugs back, but I guess not this...hopefully pic works. 393
Well, I pulled the board out of my control box and sent it in to Candcnc for repair. They repaired it, and it supposedly showed up at my parcel brokerage yesterday, so I still need to go pick it up....
It does it with the pc turned off, as soon as I switch the control box on. Going to call them once I get to the shop.
Got my new PWM module. The support I received over the phone from the folks at Candcnc was great, a pleasure to deal with. Unfortunately I plugged the new module in and it does the exact same thing....
After talking with Matt and Candcnc, looks like a problem with the PWM module. New one shipping out in the morning. Hope that does the trick!
So I visually inspected all wires and connections, unplugged all connectors and blew them out. No change. As soon as I flip the main switch on the control box, the 'Torch On' light on the pickup...
Yes, relay is staying on. I didn't have time last night to check it out other than rebooting a few times, so I'll check wiring first when I'm there later.
I always do turn plasma on after pc. The OK light on my hypertherm didn't light up because it was already getting a signal to fire torch. Rebooted everything several times, no change.
I've had my 4x8" for about a year, and for the most part it's been trouble free. Went to turn it on yesterday and as soon as I turn the switch on on the control box, it sends a signal to fire the...
I can give it a shot, but being as it only happens occasionally it's kind of a pain switching everything every time I boot it up.
Pc is plasma dedicated, not even any cad software on it. Just dropbox and a dlink, but that's been on there since pretty much day one. Problem only started recently.
Just wondering how fast everyone normally runs their tables? I've been cutting a lot of stuff between 12g and 1/4" with some pretty crisp cuts, but some of the thinner stuff I have cut gets a little...
4x8 table, once and awhile when I go to jog the machine immediately after booting everything, the x axis binds up, as if the motors aren't synched. After a few quick jogs in several directions, it's...