That is insane! Nice work - as long as I'm not paying for it ;^)
Type: Posts; User: Ciscodogg
That is insane! Nice work - as long as I'm not paying for it ;^)
Disregard - I redrilled your gear to match the offset hole in the shaft. It's dead-nuts - works great.
The Cardone had an offset hole too. You say the MSD's are drilled in the center?
Wow - that was nice of them. Hopefully the Cardone will have a centered hole and we'll be good to go. If not, I suppose it's MSD and a stiff drink LOL.
I see you posted on ifsja.com back in 2007 about being a ProComp dealer. You mentioned that "the stems are smaller" on the ProComp distributors? Just curious what your experience is with them.
...
Okay - when you said "Aftermarket or reman units are typically off center." that made me think they were all offset. If it's rare, then the reman one from O'reilly's will be centered (hopefully). ...
If I drill the shaft 90* from the current hole it will be starting in the bevel, and I'm afraid if I use the gear as a guide the bit will want to walk and oval the hole in the gear. I have another...
I bought a set of your cam/distributor gears recently. I just went to put the new distributor gear on and found the roll pin wouldn't go all the way through. After looking everything over, the hole...
Old ad - still have this intake?
Thanks!
Carter