Not sure what would cause that other than assembly Gary. Ohmic does not put ANY pressure down on the material you are cutting when the speed of the ohmic touch off is correct. It is an awesome...
Type: Posts; User: jeepsr4ever
Not sure what would cause that other than assembly Gary. Ohmic does not put ANY pressure down on the material you are cutting when the speed of the ohmic touch off is correct. It is an awesome...
Gary your a very generous guy! Let me know if you need help in any way. I am not alone here. :)
Well that is an option. We could have taken good care of you Gary. Please don't hesitate to ask.
Noted... We should be able to remap Z home. If you look on the Table I/O you will see from top to bottom X home, Y home, Z home, A home and then Limits. We can move the spade terminals from Z home to...
Gary try putting a wire across the two Z input terminals. Or a wrench to short it (Very low DC output). It is possible that the wire going to your switch has an ALMOST dead short. If you jumper the...
Gary did the wire snap where it comes out of the Z slide. There is a machined hole for the Z axis wire. There must be a short in the wire or you have a bad switch. Do you heat the building you have...
