Yes
Type: Posts; User: jeepsr4ever
Yes
This forum is not active enough. Please use 1-855-433-3689, Salesmanager@StarLabCNC.com or https://www.facebook.com/groups/475745693270992
Bob good to heard from you. I used to save magazine articles back in our old 2nd building in Lindstrom. I covered the bathroom wall with them. Since then I dont see the articles or TV shows. I know...
Send an email to orderbulltear@yahoo.com and we will send you a description
You will need to MAP Z home to B home input
First you need to know what you have. The Crankshaft harmonic balancer must be pressed in all the way first. That will set all the other pulleys. If you water pump is off .4375 or 7/16" inch then you...
They do the install and you should buy the Mini PC if you go that route. CommandCNC is very good, works great! Over 99% of folks that are happy with it. But if your voltage drops off did you press...
Not enough sold. We took out 45 products and are eliminating more due to the lack of interest.
Give it a little push it will drop it. There may be a tiny burr holding it up. The reamer is the last thing to enter the hole so if it kicked off a but as it left it would keep the plunger from going...
Hard to say. Like saying my car is noisey. Need more info or video
Vista will not work at all. You need 32 bit xp. Use the pre 2014 legacy master installer. Install mach 3 first then the bladerunner dthcii pre 2014
No special grease needed.
I think he found his issue. It is a retrofit Gary did on an older Star Lab
No ZDDP cannot do that ya knucklehead. Your over-revving did that but maybe there is more to it. You may or may not have had good valve spring pressure and you most likely hit a valve. You dont break...
1. You have disable hold checked
2. It looks like you have a stuck key on your keyboard
Just Standard grease. Do not use any high end grease as some might have a PH that is not neutral.
The thread type is 3/4-16 NOT ACME standard threads. You can use ACME if you can tap the threads to ACME but there will be no advantage other than telling folks you have ACME adjusters.
Cuts look GREAT!
Sometimes a straight edge will tell you where the misalignment is. It could be even in the idler wheel on the drivers side. If the upper part is cocked that will do it. Make sure that wheel is...
Misalignment is the ONLY way a serpentine belt squeaks unless it is so loose it isnt gripping at all. Check for misalignment...you definately have it somewhere
Good talking with you. Let us know if the issue gets resolved
When you boil it down you only need 1 5 way valve and 2 regulators. Your post is not set up to turn on both outputs at the same time.
The air cylinder on the scribe is what sets the Z depth. Youll never be able to use an air scribe that is rigid mounted without a slide and air cylinder and a torch at the same time.
The post you have been using for flat cutting also control the scribe. So if you go to Sheetcam/Options/Machine/Post processor/edit then put in these offsets for the scribe.
X -14.265
Y -59.18
Z...
The standard post you are using will work. You may have a tool (Tool 101) that may be an air scribe already.