Search:

Okay I've got a good idea where it is. It makes a big mess when the plasma comes back across the water when it's still blowing. Put a strip of .125" by 1" down the end of the slats then some 8 inch...

599

This in sheetcam or in mach? I'll have to look at this weekend. Did make some splash guards around the side that seemed to be doing well along with plumbing some water barrels under the table with...

Got my control box straightened out with candcnc. Turns out that when the water table gets cold then gets hot it sweats really bad and drips on the control box. But runs pretty good now. My concern...

Is anyoneasy using cut files from cncdxffiles.com on your Starlab machines? Thinking about purchasing some files from them and wanted to get some input.

551552553554 Just wanted to post some pictures of how good the table does cut, and how easy it is to go from 16 gauge to 3/4 material.

As long as the jumper was in it stayed on.

Okay checked between 5 and 6 while jumping 3 and 4 with 45 amp tip and came up with .2 volts

I checked with my other meter yesterday and ended up with .1 volts on the head phone jack. I'll check direct to the plug and see what I get. Do I need to get in touch with hypertherm if that test...

I'm getting .1 volt. That's with a craftsman meter. I'm gonna grab my good fluke tmrw at work and I'll test with that and see what I get.

Well got the pwm in today so I ran out to give it a try and still the same thing. Only about 8 to 10 volts show on mach. Think the 50 to 1 in the hypertherm could have died ?

Well tried leaving the screen unhooked along with the mouse and keyboard with no luck. I'm gonna try ordering some more power cables and ethernet cables that are as short as I can get away with this...

Only think that seemed to change on the power settings was the screen screen shut off time and the sleep mode time. Still shut down. Even tried turning the display to recommend setting instead of...

Still no boxes yet?

Back in town Matt so let me know when the box sends out.

Are yall out of the shop this week?

Matt
Sent you an email with a screen shot. Didn't see the Intel management on there.

Hear anything about possible problems yet?

Havnt adjusted any settings on sheet cam only settings I've changed on the computer were the acceleration values in mach that you told me to change on computer that came back. Other then that the...

Well tried the hub today and it still shuts down. Tried unplugging the eithernet cable for the plasma from the blade runner box and exact same thing. Any thoughts on what to try next

On a better note, Everything I do finnish cutting looks amazing 526

Well ran 1/0 wire from the table straight to a 5/8" 8' ground rod and still have the same issue. I don't think I can ground it more then that.524525

Well got my part back, of corse it's the same one with a note saying nothing wrong with it, and they didn't send my cable back with it so after figuring out what kinda cable it was I borrowed one...

Thank you, Just running 45 amp fine cut consumables. Using the specs in the hypertherm powermax 85 manual. Does an awsome job cutting small stuff for such a large table! Got some bottle openers to...

Well tried it again today and the torch may or may not fire when cutting don't know what happened with those headache rack inserts the other day. 98 perices and it cut out on one cut that I backed...