Search:

What version is this? or is this a custom setup?

615

Figured since I posted on another forum the results I might as well show here as well.Good cut quality
614

Hey guys,

Never tackled this yet....Need to know how to run from one edge to another in a straight line. Says edge start for this thick of material I'm guessing DTHC off? and should I draw the...

Thanks Matt helps out a lot for a NewB. And yes I was using galvinized steel and stainless....the stainless was actual part and the galvinized was test material, but now I know my test material wasnt...

Figured it out thanks, Still any advice on lead in/out would be great as I overlooked overcut as its not a prominent topic.

I see length and overcut but which arc are you talking about?
And is there a general rule of thumb for lead ins?

Lead in length was .5

Ok guys I have a Hypertherm 85 just doing some test cuts and have a simple shape of a rectangle with a complete radius at one end. Running .062 steel with 45 amp consumables. No matter what settings...