Try unplugging all the motors then fire it up. Also if your charge pump is on you wont get it to run. You re-wired a drive so maybe a loose wire to the drive, power or ground. I also have to remind...
Type: Posts; User: jeepsr4ever
Try unplugging all the motors then fire it up. Also if your charge pump is on you wont get it to run. You re-wired a drive so maybe a loose wire to the drive, power or ground. I also have to remind...
Something may be wrong with your wiring, meaning you installed the power supply. I am not sure why it wont start but the conditions of Estop off in Mach, Cable unplugged slightly, Estop button not on...
From 2 years of being bombarded with hifreq noise it was only a power supply. That is extraordinary! Youll really like it now with a nice plasma cutter.
If the relay is clicking it should be doing its job. If you take a piece of wire and cross the terminals on the relay where you put the wires for the trigger it should fire the torch. If it didnt the...
Like I mentioned you need to verify the wires don't have a short in them. You can test the wires by using a circuit testing lightbulb tool like you find at a home depot. What your doing is testing...
You may need a new relay however the outputs in the drive board gets slaughtered from continuous abuse from hi-freq. I sent you a pm and my suggestion is get the new relay. If it doesn't work your...
It is possible the relay is bad however clicking tells me it isnt. I will see if we have another relay for you here.
If the relay is clicking its doing its job. I would look for a short between relay and plasma cutter.
If the relay is clicking Mach is firing it but the wiring from the relay to the plasma cutter may be the issue.
You bombarded the controller with EMP pulses from the first plasma. A drag tip is absolutely not correct and shouldnt let the machine fire until it is contacting the plate. Clicking means the relay...