Green cut is 20:1 so not very much. I would spend the money and get something specifically designed for it. My table is clean after a 1.5 years of use.
Type: Posts; User: austinmclaen
Green cut is 20:1 so not very much. I would spend the money and get something specifically designed for it. My table is clean after a 1.5 years of use.
Austin Mclaen
331 Main Street
Forman ND 58032
507
I ended up using a product called Green Cut from Canada and have had excellent luck with it.
http://www.lubecorp.com/greencut-plasma-cnc-plasma-cutting/
Is there any setting in Mach 3 that be done to adjust which directional button on the keyboard controls the x or y direction of the gantry.
Everything is working again thanks
I tried that "Loading Default Toolset" and it brought but T1:1/8" Steel only. I deleted this tool again and tried loading default tools and it brings up the T1:1/8" so the default setting must be...
Under operation and than tool selection. I'm not seeing the appropriate material, thicknesses, and amps showing. All it says is T1. How can I get all the pre loaded tools back?
I was able to everything back up and it cut some simple shapes without any issues. If I only had Pro-E my sketching would be eAsy. I would be curious to know what was on that gave me so much...
yeah on post #10 it was sent back with the computer
Anxious to see if what you did works since it
Hasn't been used since testing at your place. I couldn't find the RS485 hub or the power cable for control box. Could these please be sent out to me?
Please see inbox for updated shipping location.
What was the root cause? Were you able to duplicate my results?
Where did Codey end up with it?
Have you had a chance to test? If not could replacement parts be sent out for me to use?
Did you experience the same results as me?
The control box and the other switch on the plasma were sent today. Also the ethernet and remaining cables were sent as well.
The controller was removed from the table during transport. Should I just send all the electronics back and exchange them for a different set?
You might have mis understood my post# 10 when is said the computer and other part went out yesterday. I just wanted to let you know I shipped them back to you.
Inconsistent cutting is the main problem I'm having. Had a couple instances of where the plasma was trying to fire, but it would just sit and fire for around 10 seconds with air, but wouldn't arc...
The PC and the RS485 port hub went out yesterday.
I replaced the yellow cat 5 cable and I was able to get it to cut better than before. Ran some good consistent cuts without any problems and were the best I have seen so far. Still had a couple...
The defender and firewall were both off. Found a video on how manually fire the torch. The torch continued to be inconsistent when it fired. Sometimes it would blow air, produce an arc, or do...
Went to cut the square and circle that I had successfully cut yesterday and it didn't fire the torch and stopped after going through the g code for the circle. I had to hit run again and than it did...
I was able to twist the ground cable into the hypotherm a little bit more and did verify the 2 green/2 red lights are on. I did a test cut and everything worked. Should I be disconnecting power...
Having some issues with my new set up after waiting a few months to get setup.
1) Sometime it will cut the first circle or line in the part and than on the next circle or line on the part it will...