Search:

this is what I posted on C&CNC forum:
664
665
666
667
668

The return value off the Y axis 'home' is just to get the gantry off the switches and understandably more than needed, but more...

this is what I posted on C&CNC forum:
664
665
666
667
668

THe return value off the home is just to get the gantry off the switches and its more than needed, but more importantly, once this...

Okay.
After going through all the config settings and setting up X so it rebounds off the switch 2x and then semi-rapid offset .15 units off the switch to reset it/give me a start/Home0 for X.
Does...

Yes, thanks for that note!
I got the twist out and took it to the next level with an auto-square kit.

Does anyone have a link as to how we do the REF_X or whatever in CommandCNC interface? All I...

Yes, thanks for that note!
I got the twist out and took it to the next level with an auto-square kit.

Does anyone have a link as to how we do the REF_X or whatever in CommandCNC interface? All I...

also,
(as from working X-Y position with 0,0 at bottom left)
stepper on left side of table is looser/easier to move when not energized than right side; is this normal, or do I need to tighten the...

Hey Matt,
My gantry is out of square square(Y-drifting on X-cuts)(straight Y-cuts)
I do not have this switch set-up on my 2014 4x8 Star-Lab/Bladerunner kit.
The kit is not available...